LED Voltage Gauge

Easy installation. Works as advertised. I hope it is actually waterproof. We'll see.

Nice size but no info included on how it works. Should all the lights on the left side be on or just one light showing the charge? I have the green light on in the middle but also all the lights to the left!

Works like a champ. No issues installing and very bright led's. I installed another brand on may other bikes and this product is much better.

I got this to replace a LED charging indicator I installed on my Sprint that I just couldn't see in the daylight. Well made, easy to connect and man is it bright! I did what one of the other posters suggested to put it in the dim mode all the time, and it is still easy to see during the day. I think I will figure out a way to flush mount it but it works great just like it is.

Every bike should have this i thought it was a great unit i wrecked my bike smashing the clear lens over the LEDs out i am surprised it still works i wrecked in the snow putting moister in it have went nearly a year to date with no clear lens to protect the circuitry and it still work amazing. I got corrosion between my regulator rectifier and my generator. the battery kept dropping all the way to failure i almost made it to work. If i had used the information presented to me i could have stopped before my battery died fixed the problem and still had enough battery to restart the bike and drive away. in short this product is wonderful. Wish it attached some way other then double sided tape

Like it. Works fine for me. Helps me to know when I need to turn off one of my accessories (heated grips, seat, GPS, phone, etc). It is very bright though and can be distracting if in a conspicuous place. I put electric tape over the photosensor to keep it 'dim' all the time.

I've been using this voltage guage for about 3 years now and have really enjoyed it. It is not waterproof, but I've not had a problem with that since the unit is mounted behind my windshield. The LEDs are bright enough to read during direct sunlight and the unit is designed to dim the LEDs to an acceptable level for night use. The only nit pick I have with the unit is accuracy. The two I've owned over the years were both off. My current one reads ab out 1.5 volts too low. But, as long as you know this up front it is not a big issue.

These are not waterproof. In a soaking rain water will seep in through the face and short circuit the unit. This can be easily fixed by getting yourself a roll of high grade 3M clear packaging tape and placing it over the face. Then use a razor blade to trim around the edges.